iScooter i10 Pro - 800W Electric Scooter

This can be due to two main reasons:

1. Safety (Assisted Start): By default, your scooter is set to "Non-Zero Start" mode. For your safety, the accelerator only activates after an initial push (give it a small push with your foot). You can change this setting via the "Minibot" app by enabling "Zero Start" mode.
2. Technical Issue: If an error code appears on your LCD screen, this may indicate a malfunction of the accelerator. In this case, please contact us for a part replacement.

• 1 x i10 Pro Electric Scooter
• 1 x AC Charger
• 1 x Scooter Storage Bag
• 6 x Mounting Screws
• 1 x Allen Key (Hex Key)
• 1 x i10 Pro User Manual

This error usually indicates a connection problem with the internal motor sensors. To resolve this issue:

1. Disassembly: Remove the screws located under the scooter's chassis.
2. Check: Access the controller located inside.
3. Maintenance: Disconnect and then firmly reconnect the terminal of the Hall cable (bundle of thin wires connected to the motor).
   If the error code persists, contact our technical team.

If your device is unresponsive, please follow these two diagnostic steps:

1. Charger Check: Unplug the charger from the scooter's charging port, then briefly press the power button. Note: Some models do not power on while charging.
2. Voltage Measurement: Use a multimeter to test the battery voltage.Between 30V and 42V: Your battery is functional. The problem is likely with the display or controller.Below 30V: The voltage is too low to start the system. Your battery may require replacement or deep charging.

If your device is no longer charging, follow these diagnostic steps:

1. Visual Inspection: Check the condition of your charging cable and the charging port. If there are signs of damage (cuts, burns), do not use these accessories for safety reasons.
2. Voltage Test (Multimeter): Set your multimeter to AC 220V to test the charger's output and the charging port:No Reading: The charger or charging port is faulty and needs to be replaced.Reading Present: If the voltage is present but the device is not charging, the battery is likely at the end of its life and needs replacement.

This noise usually comes from the disc brake. To eliminate this squealing or rubbing sound, follow these steps (make sure the scooter is turned off):

1. Loosen: Loosen the two screws on the brake caliper (caution: do not touch the lever arm screw).
2. Align: Adjust the caliper position so that the brake disc is exactly centered between the two pads.
3. Check: Make sure the disc and pads do not touch when the wheel spins freely.
4. Secure: Hold the caliper in this position, then firmly retighten the screws.
   Need help? Contact our customer service to receive a demonstration video.

The stated performance figures are based on tests under optimal conditions. In real-world use, maximum speed and battery life vary depending on several key factors:

1. Environmental conditions: Outside temperature (cold reduces battery efficiency).
2. Terrain type: Road conditions, inclines, or uneven surfaces.
3. Payload: The user's total weight (including accessories and backpacks).
   To optimize your battery life, we recommend maintaining adequate tire pressure and smooth driving.